1. Design criterias

2. Hydraulic performance

Interactive graphics: Point on your preferred design flow and pressure. The curve shows up to 5.0m pressure head. For capacity at higher pressure heights, contact MFT. All models are listed in the table below.

3. Models overview

Remarks: PVC socket is not included in the delivery. All measurements given in [mm] unless otherwise specified.

Remark: FluidVertic has submerged inlets, which contribute to increased operational reliability. In order to reduce the risk of clogging, the system should be designed to prevent large particles to reach the inlet of the vortex chamber (e.g. submerged outlet from upstream manhole, scum board infront of vortex chamber, etc.). This is particularly important for vortex chambers with a flow cross-section (DN) below 50 mm.